Detailed description
2.3 Axis/spindle service display
Basic logic functions: Diagnostic tools (D1)
16 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
"Referenced" status display
Status display for reference point approach (axis).
Bit0=Status 0: The machine axis is not cross-referenced using position measurement
system 1 or 2.
Bit0=Status 1: The machine axis has reached the reference point (incremental
measuring system) and/or target point (length measuring system with
distance coded reference marks) during reference point approach.
Bit1=Status 0: No obligation to cross-reference (NC start possible without cross-
referencing this axis)
Bit1=Status 1: There is no obligation to cross-reference for the NC start.
Depending on machine data:
MD34110 $MA_REFP_CYCLE_NR
and
MD20700 $MC_REFP_NC_START_LOCK
Display corresponds to
IS DB31, ... DBX60.4 and 60.5 ("Referenced/synchronized 1 or 2").
References:
/FB1/ Function Manual Basic Functions; Reference Point Approach (R1)
QEC learning active
Indicates whether or not the learning process for quadrant error compensation for the axis is
active.
Fixed stop reached
Indicates whether or not the axis has fulfilled the conditions for "Fixed stop reached" when
the "Travel to fixed stop" function is active (IS DB31..., DBX62.5).
References:
/FB1/ Function Manual Basic Functions; Travel to Fixed Stop (F1)
Torque limitation value
Indicates the value programmed by means of
FXST[x] or
SD43510 $SA_FIXED_STOP_TORQUE
or the value defined with machine datum:
MD37010 $MA_FIXED_STOP_TORQUE_DEF
for the clamping torque for "Travel to fixed stop".
Unit: % of maximum torque
References:
/FB1/ Function Manual Basic Functions; Travel to Fixed Stop (F1)
To Next Page
Loading...
Need help?
General
