Brief description
1.2 Overview of auxiliary functions
Basic logic functions: Auxiliary Function Output to PLC (H2)
8 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Application
Controlling machine functions in synchronism with the part program.
General remarks
• The following M functions have a predefined meaning: M0, M1, M2, M17, M30
M3, M4, M5, M6, M19, M70, M40, M41, M42, M43, M44, M45.
• For each M function (M0 - M99), there is a dynamic signal at the NC/PLC interface that
indicates the validity (new output) of the M function. In addition, 64 additional signals can
be assigned for user M functions.
References:
/FB1/ Function Manual, Basic Functions, Basic PLC Program (P3)
• For subprograms, machine data can be used to set whether an output of the M function
should be undertaken for the end of the part program M17, M2 and M30 to the PLC:
MD20800 $MC_SPF_END_TO_VDI (subprogram end to PLC)
• For the predefined M function M40 – M45, only limited redefinition of the output
specification is possible.
• The predefined auxiliary functions M0, M1, M17, M30, M6, M4, M5 cannot be redefined.
• M-function-specific machine data:
– MD10800 $MN_EXTERN_CHAN_SYNC_M_NO_MIN
– MD10802 $MN_EXTERN_CHAN_SYNC_M_NO_MAX
– MD10804 $MN_EXTERN_M_NO_SET_INT
– MD10806 $MN_EXTERN_M_NO_DISABLE_INT
– MD10814 $MN_EXTERN_M_NO_MAC_CYCLE
– MD10815 $MN_EXTERN_M_NO_MAC_CYCLE_NAME
– MD20094 $MC_SPIND_RIGID_TAPPING_M_NR
– MD20095 $MC_EXTERN_RIGID_TAPPING_M_NR
– MD20096 $MC_T_M_ADDRESS_EXT_IS_SPINO
– MD22200 $MC_AUXFU_M_SYNC_TYPE
– MD22530 $MC_TOCARR_CHANGE_M_CODE
– MD22532 $MC_GEOAX_CHANGE_M_CODE
– MD22534 $MC_TRAFO_CHANGE_M_CODE
– MD22560 $MC_TOOL_CHANGE_M_CODE
To Next Page
Loading...
