Siemens SINUMERIK 810D Function Manual

Detailed description
2.7 Program operation mode
Basic logic functions: Mode group, channel, program operation, reset response (K1)
140 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
User ASUB
User routine protection level
If a user-defined routine is to be used, i.e., if there is a value not equal to 0 in
MD11610 $MN_ASUP_EDITABLE, then a protection level can be defined for the user-
specific routine _N_ASUP_SPF. The protection level can be set to values between 0 and 7
and must be entered in It must be specified in MD11612
$MN_ASUP_EDIT_PROTECTION_LEVEL (protection level of the user-specific ASUP
program. For further information about protection levels, refer to:
References:
/IADC/ Commissioning Manual; Protection Level Concept
Single-block processing
Bit 0 in machine data MD10702 $MN_IGNORE_SINGLEBLOCK_MASK (prevent single
block stop) determines whether internal ASUPs or the described user ASUPs are to be
executed without interruption after every block even when single-block processing is
selected:
Bit 0 set: Internal ASUBs are not stopped in any block.
Bit 0 not set Internal ASUBs are stopped in every block.
Danger
The machine manufacturer is responsible for the contents of ASUB routines used to replace
ASUP.SYF supplied by Siemens.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English