To Next Page

To Previous Page

Table of contents

Basic logic functions: Axis monitoring, protection zones (A3)

4 Function Manual, 11/2006, 6FC5397-0BP10-2BA0

4.1.1 Working area limitation in WKS/ENS .......................................................................................... 65

4.2 Protection zones ......................................................................................................................... 68

4.2.1 Definition and activation of protection zones .............................................................................. 68

5 Data lists.................................................................................................................................................. 79

5.1 Machine data............................................................................................................................... 79

5.1.1 NC-specific machine data ........................................................................................................... 79

5.1.2 Channelspecific machine data .................................................................................................... 79

5.1.3 Axis/spindlespecific machine data .............................................................................................. 80

5.2 Setting data ................................................................................................................................. 81

5.2.1 Axis/spindlespecific setting data ................................................................................................. 81

5.3 Signals......................................................................................................................................... 82

5.3.1 Signals to channel....................................................................................................................... 82

5.3.2 Signals from channel................................................................................................................... 82

5.3.3 Signals to axis/spindle................................................................................................................. 83

Index........................................................................................................................................................ 85