Siemens SIRIUS Series

Installation/Removal
8.2 Removing the SIRIUS 3RA6 compact starter and AS-i mounting module
SIRIUS 3RA6 Compact Starter
64 System Manual, 02/2008, GWA 4NEB 560 0601-02 DS 02
8.2 Removing the SIRIUS 3RA6 compact starter and AS-i mounting
module
The sections below explain how to remove the SIRIUS 3RA6 compact starter from:
● A DIN rail
● A level surface (screw fastening)
● The infeed system for 3RA6
The process of removing the AS-i mounting module from the compact starter (24 V) is also
described.
8.2.1 Removing the compact starter from a DIN rail
Requirements
● The compact starter must be switched off (actuator set to OFF position).
● The AS-i cables must be removed.
Note
Disassemble the compact starter's main and control conductor terminal blocks before
removing it, as this makes the process easier.
Procedure
Step Instructions Image
1 Pull the device down until the lower half
can be pulled away from the DIN rail.
2 Pull the lower half of the device away
from the DIN rail and lift the device off
its upper edge.