Siemens SITRANS FUG1010 IP65 NEMA 4X - Page 239

Step 1-R: Mounting the Straps For Reflect Mode
A. Determine the mounting plane of the path/s
See Fig 1-1 and refer to General Notes on page
1 of 8. Take up the slack in the strap and locate
the keeper/s at the selected plane/s. Locate
the Screw-Lock Buckle 180 degrees from
nearest Keeper or best location. See Fig 1-6.
B. Bend the loose end of the strap to prevent it
from loosening while you install and tighten the
setscrew you retained from Step1-C. See Fig 1-
7.
C. Fig 1-8 shows the final results of Step 1-R.
Continue to Step 2.
Pa
g
e 3 of 9
1012WS-1-7 Rev B
Fi
g
1-6
Fi
g
1-7
Fi
g
1-8
All Keepers are
aligned with each
other and inline
with the pipe axis.
Keepers
Screw Lock
Buckle