3-10
1010GCNFM-3CSection 3
4. Press and hold the <Down Arrow>. Note that the capitalized alphabet list begins to scroll downward
through the alphabet from [S]. Stop scrolling at letter [I]. Press the <Right Arrow> to move the block
cursor to the third character position.
5. Scroll back up to letter [T]. Move the cursor to the fourth character position. Scroll down to letter [E].
Move the cursor to the fifth character position. Type [1] on the numeric keypad to complete the site
name.
6. Press <ENT> to create the site setup named [SITE1]. Note that the name now appears in the [Save/
Rename Site] menu cell and on the upper right corner of the graphic screen.
Siemens Dual Path 2IN
Recall Site Setup No Sites
Channel Enable No
Create/Name Site ?SITE1



Site Security Off
Delete Site Setup No Sites
Save/Rename Site
Right Arrow & Enter Creates a new Site
Channel/Path Setup
Siemens Dual Path SITE1
Recall Site Setup No Sites
Channel Enable No
Create/Name Site SITE1
Site Security Off
Delete Site Setup No Sites
Save/Rename Site SITE1
Use with Care -- Turn Security On or Off
Channel/Path Setup
After creating a Site
Setup, the assigned
name appears in
these places.
To Next Page
Loading...
Need help?
General
