Automatic Adjustment Procedure
1. In the [Site Setup Data] Menu, press the <Down Arrow> and scroll to the [HF] menu cell.
Press the <Right Arrow> and a pop-up [Manual] prompt will appear.
2. Press the <Up or Down Arrow> to select [Automatic] then press <ENT>.
3.
The current measured correction value is displayed (see below).
Troubleshooting
10.4 Site Setup Data
FUP1010 IP67 Portable Flowmeter
132
Operating Instructions, 02/2010, A5E02951522A Revision 01
To Next Page
Loading...
