8. Next, left-click on the [ASCII Setup] button (see screen above). In the [ASCII Sending]
dialog box, make
sure that both [send line ends with line feeds] and [Echo Typed characters
locally] are UNCHECKED. In the [ASCII Receiving] dialog box, left-click to place a check
mark before the [Append line feeds to incoming line ends] dialog. When your screen looks
like the example below, left-click the [OK] button.
9. You are now ready to communicate with the 1010 flowmeter. But first, save your settings
by moving the
mouse cursor to [File], sliding the cursor to [Save], then clicking [OK] on the
Save dialog box.
10.The next time you want to use HyperTerminal:
● Click on Start.
● Drag to Programs.
● Drag to Accessories. Drag to [Communications], and click.
● Double-click the icon you selected for the connection.
Note
For easier access,
create a shortcut to the connect icon from your desktop. Right-click on
the icon to open its dialog box. Left-click on [Copy] or [Create a Short Cut] and then move
the mouse cursor to a blank area on your desktop. Right-click to open dialog box and then
left-click on [Paste] to place a shortcut to the connect icon on your desktop.
Accessing the Installation Menu
Once the parameters are set, HyperTerminal automatically initiates Command mode. You will
see a blank screen.
1. Press <Enter> a few times until you see [? For Help] on the screen.
2. Type: ? (question mark) and then press <Enter> to see a list of the available commands.
Use the MENU command (type [Menu] and then press <Enter>) to access the top level of the
Installation Menu. You will see a screen similar to the example below.
Appendix
A.4 Site Setup For SITRANS F
FUP1010 IP67 Portable Flowmeter
140
Operating Instructions, 02/2010, A5E02951522A Revision 01
To Next Page
Loading...
