Note
To facilitate connecting through
modems, the [Menu] command times out after three minutes
of inactivity. To maintain a longer connection, type: Menu 1000 and press <Enter>. The
optional number is the amount in minutes that the connection will be maintained. Typing
[Menu 1000] essentially keeps the interface active until you cancel it.
Data Display Mode
After you complete the installation, you can toggle between Installation Menu mode to Data
Display mode. This is the same as using the <MENU> key on the keypad. The PC keyboard
equivalent to the <MENU>
key is <Ctrl> + <L>. Note that the RS-232 interface does not support
graphics. Therefore, when you use HyperTerminal to view the data display screens, you will
see the same data in alphanumeric form only (as shown below). You can still use the <Up
Arrow> and <Down Arrow> to switch between available display screens.
① Current active site setup name. The [1]
indicates that the measurement
channel is
active.
③ The flow Total display.
Appendix
A.4 Site Setup For SITRANS F
FUP1010 IP67 Portable Flowmeter
Operating Instructions, 02/2010, A5E02951522A Revision 01
141
② The current measured sonic velocity. ④ The current flow reading and flow units.
To Next Page
Loading...
