Navigating through the Installation Menu
After accessing the Installation Menu, you can begin to setup your flowmeter according to the
instructions in this manual. The chart below shows the PC keyboard equivalents to the keypad
keys while you are in the menu.
SITRANS F 1010 Keyboard PC Keyboard Description
<Up Arrow> <Up Arrow> Move up 1 menu cell (or Flow Display
screen)
<Down Arrow> <Down Arrow> Move down 1 menu cell (or Flow Display
screen)
<Right Arrow> <Right Arrow> Move right 1 menu cell (or Flow Display
screen)
<Left Arrow> <Left Arrow> Move left 1 menu cell (or Flow Display
screen)
<Menu> ^L (Cntrl L) Toggle between Menu and Flow Display
<Datalog> ^D (Cntrl D) Generate Datalogger report
<CLR> <Backspace> or <DEL> Deselect list selection
<ALT+Up Arrow> ^U (Ctrl U) Logger Display Page Advance
<+/-> (chg sign) | (bar, shift + backslash) Change numeric sign. Can also type (-)
key
<ENT> <Carriage Return> Enter Key
Digits Digits Numerals 0 through 9
/ / Divide by
X * (shift + upper case 8) Multiply by
+ + Plus
- - Minus
= = Equals
. . Decimal Point
Terminal Mode Menu Commands
In addition to Menu, the following commands (followed by the <ENT> key) can be used to
control the flowmeter while in Terminal Mode.
Note
The "n" refers to the flowmeter Channel number. For a dual channel Arithmetic site (Ch1 +
Ch2 or Ch1 – Ch2) the virtual Channel is number 3.
Appendix
A.4 Site Setup For SITRANS F
FUP1010 IP67 Portable Flowmeter
142
Operating Instructions, 02/2010, A5E02951522A Revision 01
To Next Page
Loading...
