4. Scroll to [Save/Rename Site]. Press <Right Arrow> then press <ENT> to save site.
5. Press <Left Arrow> and return to the main menu.
Select Pipe Class
1. Press the <Down Arrow> and then <Right Arrow> to highlight [Pipe Data].
2.
Press the <Right Arrow> to select Pipe Class. Press <Right Arrow> again and scroll to
desired Pipe Class.
3. Press <ENT> to select.
4. Pre-programmed Pipe Size and relevant pipe parameters will appear in menu cells. Press
<Right Arrow> and scroll to desired pipe size. Press <ENT>. Enter dimensions manually if
pre-programmed dimensions do not match application.
5. Press the <Left Arrow> and return to the main menu.
Select a Liquid Class
1. Press the <Down Arrow> and scroll to [Application Data].
2. Press the <Right Arrow> to select [Liquid Class].
3.
Press the <Right Arrow> again and scroll to desired liquid.
4. Press <ENT> to save selection.
① Select from list.
Connecting
5.2 Sensor Wiring
FUP1010 IP67 Portable Flowmeter
Operating Instructions, 02/2010, A5E02951522A Revision 01
35
To Next Page
Loading...
