SimCom SIM700C

Smart Machine Smart Decision
SIM7000 Series_AT Command Manual_V1.03 114 2018-05-08
AT+CGACT=?
+CGACT: (list of supported <state>s)
OK
Parameters
See Write Command
Read Command
AT+CGACT?
Response
+CGACT: <cid>,<state>[<CR><LF>+CGACT: <cid>,<state>…]
OK
Parameters
See Write Command
Write Command
AT+CGACT=<st
ate>[,<cid>[,<cid
>[,…]]]
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters
<state> Indicates the state of PDP context activation
0 Deactivated
1 Activated
Other values are reserved and will result in an ERROR
response to the Write Command.
<cid> A numeric parameter which specifies a particular PDP context
definition (see +CGDCONT Command). If the <cid> is
omitted, it only affects the first cid.
<cid> values 17 to 24 are supported from MPSS JO 1.0+
onwards.
1…24
Parameter Saving
Mode
NO_SAVE
Max Response
Time
150 seconds
Reference Note
 This command is used to test PDPs with network simulators.
Successful activation of PDP on real network is not guaranteed.
6.2.4 AT+CGPADDR Show PDP Address
AT+CGPADDR Show PDP Address
Test Command
AT+CGPADDR=
?
Response
+CGPADDR: (list of defined <cid>s)
OK
Parameters
SIMCOM COMFIDENTIAL FILE