SimCom SIM700C

Smart Machine Smart Decision
SIM7000 Series_AT Command Manual_V1.03 137 2018-05-08
1) For single IP connection (+CIPMUX=0)
+IPD,<data length>:
2) For multi IP connection (+CIPMUX=1)
+RECEIVE,<n>,<data length>:
Parameter Saving
Mode
NO_SAVE
Max Response
Time
-
Reference Note
8.2.17 AT+CIPATS Set Auto Sending Timer
AT+CIPATS Set Auto Sending Timer
Test Command
AT+CIPATS=?
Response
+CIPATS: (list of supported <mode>s),(list of supported <time>)
OK
Parameters
See Write Command
Read Command
AT+CIPATS?
Response
+CIPATS: <mode>,<time>
OK
Parameters
See Write Command
Write Command
AT+CIPATS=<m
ode>[,<time>]
Response
OK
ERROR
Parameters
<mode> A
numeric parameter which indicates whether set timer when
module is sending data
0 Not set timer when module is sending data
1 Set timer when module is sending data
<time> 1..100 A numeric parameter which indicates the seconds
after which the data will be sent
Parameter Saving
Mode
NO_SAVE
Max Response
Time
-
Reference Note
SIMCOM COMFIDENTIAL FILE