SimCom SIM700C

Smart Machine Smart Decision
SIM7000 Series_AT Command Manual_V1.03 139 2018-05-08
Read Command
AT+CIPSERVE
R?
Response
+CIPSERVER: <mode>[,<port>,<channel id>,<bearer>]
OK
Parameters
See Write Command
Write Command
AT+CIPSERVE
R=<mode>[,<por
t>]
Response
OK
ERROR
Parameters
<mode> 0 Close server
1 Open server
<port> 1..65535 Listening port
<channel id> Channel id
<bearer> GPRS bearer
Parameter Saving
Mode
NO_SAVE
Max Res
ponse
Time
-
Reference Note
This command is allowed to establish a TCP server only when the state is IP
INITIAL or IP STATUS when it is in single state. In multi-
IP state, the state
is in IP STATUS only.
8.2.20 AT+CIPCSGP Set GPRS for Connection Mode
AT+CIPCSGP Set GPRS for Connection Mode
Test Command
AT+CIPCSGP=?
Response
+CIPCSGP: 1-GPRS,APN,USER NAME,PASSWORD
OK
Parameters
See Write Command
Read Command
AT+CIPCSGP?
Response
+CIPCSGP: <mode>,<apn>,<user name>,<password>[,<rate>]
OK
Parameters
See Write Command
Write Command
AT+CIPCSGP=<
mode>[,(<apn>,<
Response
OK
ERROR
SIMCOM COMFIDENTIAL FILE