SimCom SIM700C User Manual

Smart Machine Smart Decision
SIM7000 Series_AT Command Manual_V1.03 35 2018-05-08
Test Command
AT+IFC=?
Response
+IFC: (list of supported <dce_by_dte>s),(
list of supported
<dte_by_dce>s)
OK
Parameters
See Write Command
Read Command
AT+IFC?
Response
+IFC: <dce_by_dte>,<dte_by_dce>
OK
Parameters
See Write Command
Write Command
AT+IFC=<dce_b
y_dte>[,<dte_by
_dce>]
Response
This parameter setting determines the data flow control on the serial
interface for data mode.
OK
Parameters
<dce_by_dte> Specifies t
he method will be used by TE at receive of
data from TA
0 No flow control
1 Software flow control
2 Hardware flow control
<dte_by_dce> S
pecifies the method will be used by TA at receive of data
from TE
0 No flow control
1 Software flow control
2 Hardware flow control
Parameter Saving
Mode
-
Max Response
Time
-
Reference
V.25ter
Note
2.2.32 AT+IPR Set TE-TA Fixed Local Rate
AT+IPR Set TE-TA Fixed Local Rate
Test Command
AT+IPR=?
Response
+IPR: (list of supported auto detectable <rate>s),(
list of supported
fixed-only <rate>s)
SIMCOM COMFIDENTIAL FILE

SimCom SIM700C Specifications

General

Brand	SimCom
Model	SIM700C
Category	Control Unit
Language	English