SimCom SIM700C

Smart Machine Smart Decision
SIM7000 Series_AT Command Manual_V1.03 122 2018-05-08
AT+CIPSGTXT Select GPRS PDP context
AT+CIPSENDHEX Set CIPSEND Data Format to HEX
AT+CIPHEXS Set Output-data Format with suffix
AT+CIPTKA Set TCP keepalive parameters
AT+CIPOPTION Enable or Disable TCP nagle algorithm
8.2 Detailed Descriptions of Commands
8.2.1 AT+CIPMUX Start Up Multi-IP Connection
AT+CIPMUX Start Up Multi-IP Connection
Test Command
AT+CIPMUX=?
Response
+CIPMUX: (0,1)
OK
Parameters
See Write Command
Read Command
AT+CIPMUX?
Response
+CIPMUX: <n>
OK
Parameters
See Write Command
Write Command
AT+CIPMUX=<
n>
Response
OK
Parameters
<n> 0 Single IP connection
1 Multi IP connection
Parameter Saving
Mode
NO_SAVE
Max Response
Time
-
Reference
Note
 Only in IP initial state, AT+CIPMUX=1 is effective;
 Only when multi IP connection and GPRS application are both shut
down, AT+CIPMUX=0 is effective.
8.2.2 AT+CIPSTART Start Up TCP or UDP Connection
AT+CIPSTART Start Up TCP or UDP Connection
Test Command Response
SIMCOM COMFIDENTIAL FILE