SimCom SIM700C

Smart Machine Smart Decision
SIM7000 Series_AT Command Manual_V1.03 123 2018-05-08
AT+CIPSTART=
?
1) If AT+CIPMUX=0
+CIPSTART: (list of supported <mode>),(<IP address>),(<port>)
+CIPSTART: (list of supported <mode>),(<domain name>),(<port>)
OK
2) If AT+CIPMUX=1
+CIPSTART: (list of supported <n>),(list of supported <mode>),(<
IP
address>),(<port>)
+CIPSTART: (list of supported <n>),(list of supported <mode>),(<
domain
name>),(<port>)
OK
Parameters
See Write Command
Write Command
1)If single IP
connection
(+CIPMUX=0)
AT+CIPSTART=
<mode>,<IP
address>,<port>
Or
AT+CIPSTART=
<mode>,<domai
n name>,<port>
2)If multi-
IP
connection
(+CIPMUX=1)
AT+CIPSTART=
<n>,<mode>,<ad
dress>,<port>
AT+CIPSTART=
<n>,<mode>,<do
main name>,
<port>
Response
1)If single IP connection (+CIPMUX=0)
If format is right response
OK
otherwise response
If error is related to ME functionality:
+CME ERROR <err>
Response when connection exists
ALREADY CONNECT
Response when connection is successful
CONNECT OK
Otherwise
STATE: <state>
CONNECT FAIL
2)If multi-IP connection
(+CIPMUX=1)
If format is right
OK,
otherwise response
If error is related to ME functionality:
+CME ERROR <err>
Response when connection exists
<n>,ALREADY CONNECT
If connection is successful
<n>,CONNECT OK
Otherwise
<n>,CONNECT FAIL
Parameters
SIMCOM COMFIDENTIAL FILE