128
13. Subtract the position from where the car stopped at (from
Step #12) from the known position of the DET magnet (from Step
#8). This will be the actual slide distance of the car.
Slide Distance: ____’ ____”
14. Position the UET magnet no less than the slide distance
measured from the middle of the terminal landing DZ magnet
down to the top of the UET magnet.
NOTE: This distance is the MINIMUM distance to install the UET magnet.
The magnet can be placed at a greater distance but verify that it is not
outside the highest speed profile’s slowdown distance.
Once both magnets are placed in the proper location move the car to the
bottom terminal landing and perform the learn function again (see
“Learning the Hoistway” section). This will save the new locations of the
ETS magnets.
To Next Page
Loading...