Smartrise F220

209
 Learns the position of all magnets for programmed landings.
 MAIN MENU | SETUP | DOOR SETUP |
 MANUAL OPEN AND CLOSE
 Allows the user to open or nudge the doors closed on any mode of inspection.
 DOOR DWELL HC
 The amount of time the controller will wait before asserting door close at the lobby. This time may be
canceled by pressing the door close button or a car call button.
 DOOR DWELL CC
 The amount of time the controller will wait before asserting door close at a non-lobby landing. May
be canceled as above.
 DOOR DWELL REOPEN
 The amount of time the controller will wait before asserting the Door Close (DC) command after a
reopen command is given.
 NUDGING TIME
 The amount of time the controller will permit the photo eye (PHE) to be obstructed before asserting a
nudging command. If left at “0” door nudging will be disabled.
 LOCK CLIP TIME
 The amount of time the controller will disregard an open hall lock. This prevents intermittent
interlock faults and for safety reasons this timer should not exceed .5 seconds.
 PREOPENING
 When enabled (Yes) this parameter enables preopening of the doors while the car is leveling and in a
Door Zone. Enabled after properly calibrated.
 NO DEMAND DOOR OPEN
 Allows the user to keep the car doors open at a landing with no active calls present.
 DC ON ANY MOVE
 Applies a squeeze command when the car moves in any direction.
 DETECT DOOR JUMPERS
 With this setting enabled (Yes) the controller will check that the gate switch and hall lock inputs mate
and de-mate each time a door cycle occurs. Do not adjust without direction from Smartrise.
 TIMEOUT OPEN
 This timer is the maximum length of time the controller will expect the Door Open Limit (DOL) to
activate after issuing a Door Open (DO) command.
 TIMEOUT CLOSE
 This timer is the maximum length of time the controller will expect the Door Close Limit (DCL) to
activate after issuing a Door Close (DC) command.
 TIMEOUT NUDGE
 This timer is the maximum length of time the controller will expect the Door Close Limit (DCL) to
activate after issuing a Nudge command.
 AUTO CLOSE
 Turns on/off the auto close command (DC) for automatic doors.
 AUTO OPEN
 Turns on/off the auto open command (DO) for automatic doors.
 SWING REOPENS CAR
 For manual hall swing doors: when enabled (yes) opening the swing door will cause the controller to
issue a door reopen command.
 DC WARNING TIME
 This timer is the amount of time the door close buzzer goes off prior to the controller issuing a Door
Close (DC) command.