Sola PROSEM K BASIC Series - Machine Identification; Use According to Design

12
5
Fig. 3.2
1
2
34
OVERVIEW
3.2 MACHINE IDENTIFICATION
Every machine has an IDENTIFICATION PLATE in the three-point linkage that species:
1- Name and address of the manufacturer.
2- Machine model.
3- Machine type.
4- Serial number.
5- CE certicate.
3.3 USE ACCORDING TO DESIGN
The precision planter PROSEM has been designed specically for single-seed sowing of cereal
and other grain seeds.
The machine has been designed to work using an agricultural tractor with lifting unity and
three-point universal linkage.
This machine is able to work by using either a PTO shaft plugged into the tractor’s PTO or by
means of a hydraulic engine.
If the machine is used in circumstances other than those specied above, the manufacturer will
not be held responsible for any damage caused to persons or to the machine.
The user must observe all regulations concerning safety, trac and hygiene.
If the machine is modied by the user, the manufacturer’s warranty is cancelled. SOLÁ will not
be held responsible for any damage caused to persons or to the machine.
The use of seeds with a high moisture content should be avoided since they can cause blockages.