Sola PROSEM K BASIC Series - Frames

17
OVERVIEW
IF THE CASE OF USING NON-MANUAL SPECIFIED SEEDS IN THE SEED DISCS, TAKE INTO ACCOUNT
THAT WHEN THE HOLE IS BIGGER THAN EACH SEED, THESE SEEDS MAY BE ABSORBED BY THE
SUCTION SYSTEM AND THEREFORE WILL NOT REACH THE FURROW BED.
BEFORE STARTING TO SOW, CHECK THAT THE TYPE OF SEED DISCS ASSEMBLED IN THE METE-
RING BOXES MATCHES THE TYPE OF SEED TO BE USED.
3.7 FRAMES
The frame has three universal coupling points for tractors. This part of the machine is where all
the metering units are assembled to. Some types of frame allow to adjust the row spacing.
There are dierent frame models:
- FIXED
- VARIANT MANUAL FIXED
- TELESCOPIC
- VARIANT
- VARIANT IDRA
- FOLDING
ALL MACHINES CAN RUN ON PUBLIC ROADS, YET ARE PROHIBITED IF THEY ARE EQUIPPED WITH
FIXED FRAME OR VARIANT MANUAL FIXED FRAME WHOSE WIDTH IS NOT ALLOWED ACCORDING TO
EACH COUNTRY’S LEGISLATION. IN THESE CASES, RUNNING ON PUBLIC ROADS WILL ONLY BE LE-
GAL IF THE MACHINE HAS THE OPTIONAL LONGITUDINAL TRANSPORT TROLLEY (3.13). IN THIS CASE,
TRANSPORT WIDTH WILL BE 3 METRES.
THE PLANTER CAN WORK AS A TRAILED MACHINE IF IT IS EQUIPPED WITH THE FRONT WORK
TROLLEY AS OPTIONAL EQUIPMENT (3.14). TRANSPORT OF THE PLANTER ON PUBLIC ROADS
USING THIS TROLLEY WILL BE LIMITED BY THE PLANTER’S WORKING WIDTH AND TRAFFIC RE-
GULATIONS.
See section 4. TECHNICAL CHARACTERISTICS in order to know if the machine supports optional
equipment.
T
A
T
T
T
FORW
FORW
ORW
W
FO
ARD
ARD
RD
D
A
DIRE
IRE
DIR
D
CTIO
TIO
O
CTI
CT
N
N
Fig. 3.14
Fig. 3.13
FORW
RW
FORW
FORW
FO
ARD
D
D
ARD
TRAN
RAN
TRAN
TR
T
SPOR
POR
SPO
SPO
T
T
FO
FO
FOR
ORW
W
AR
AR
ARD
D
W
WOR
OR
ORK
K