Sola PROSEM K BASIC Series - Folding Machine; Fixed Folding Machine; Idra Folding Machine; Omnia Folding Machine

64
Fig.6.57
A
B
ADJUSTMENTS
6.5.6 FOLDING MACHINE
To adjust the spacing between metering units in folding machines, it is necessary to operate on:
THE CENTRAL FRAME (A, Fig. 6.57).
The FOLDING PARTS (B, Fig. 6.57).
6.5.6.1 FIXED FOLDING MACHINE
To adjust the row spacing of the central frame and the folding parts, follow as indicated in sec-
tion 6.5.1 FIXED MACHINE.
6.5.6.2 VARIANT MANUAL FIXED FOLDING MACHINE
To adjust the row spacing of the central frame and the folding parts, follow as indicated in sec-
tion 6.5.2 VARIANT MANUAL FIXED MACHINE.
6.5.6.3 TELESCOPIC FOLDING MACHINE
The row spacing of this machine can not be adjusted.
6.5.6.4 IDRA FOLDING MACHINE
The row spacing of this machine can not be adjusted.
6.5.6.5 OMNIA FOLDING MACHINE
To adjust the row spacing of the central frame follow as indicated in section 6.5.5 VARIANT IDRA
MACHINE. To adjust the row spacing of the folding parts follow as indicated in section 6.5.2 VA-
RIANT MANUAL FIXED MACHINE.