H6 Hybrid Inverter - Installation & Operation Guide
104
Copyright 2017 SolarCity Corporation. All rights reserved.
3. Write down as much information as possible about all of the following:
- Specific message appearing on the LCD display. Alternatively, if no message is
appearing, describe the inverter behavior in as much detail as possible.
- Operating protected home loads at the instance.
- Battery pack condition (voltage, power, state of charge, etc.).
- Recent events (such as if the AC grid failed and the inverter failed to power the
protected home loads).
- Any known anomalies in the AC grid, such as low voltage or brownouts.
- Any extreme temperatures, humidity, and/or weather that could be a factor.
4. Check for any tripped AC breakers in all of the following locations:
- Back-feeder Main electrical panel.
- Backup load panel
- AFCI/GFCI/standard breakers in the Backup panel.
5. Verify that the Fireman Switch has not been pushed in. If needed, see
“Fireman Switch”
on page 71
for reset instructions.
6. Contact Delta Customer Service for further assistance as described in
“Technical
Support” on page 10
. Please be prepared to provide all pertinent information, including
the model and serial number of the SolarCity H6 inverter.
To Next Page
Loading...