79
Copyright 2017 SolarCity Corporation. All rights reserved.
Chapter 1 - Welcome
6.2.2 - Current Status Menu
This menu presents messages about the current system status. This will be one of the
following:
• Operation Mode: Auto or System Control: This is normal. The green LED is lit.
• Operation Mode: Forced Charge: This is normal. The green LED is lit.
• Operation Mode: Forced Discharge: This is normal. The green LED is lit.
• Operation Mode: PFC: This is normal. The green LED is lit.
• Grid under frequency: Grid frequency has dropped below the specified minimum. The
green LED blinks once per second.
• Grid over frequency: Grid frequency has increased above the specified maximum. The
green LED blinks once per second.
• Grid underVolt: Grid voltage has dropped below the specified minimum. The green LED
blinks once per second.
• Grid overVolt: Grid voltage has increased above the specified maximum. The green LED
blinks once per second.
• System Fault in Inverter: There is a system fault within the SolarCity H6 inverter.
• Battery Fault: There is a fault within the Battery Pack.
6.2.3 - External Messages Menu
This menu displays up to four (4) text messages sent from SolarCity to the inverter via the
wireless ZigBee connection. Each message can contain up to 16 characters.
6.2.4 - Software Versions Menu
This menu presents a scrolling list of the firmware versions installed in the SolarCity H6
inverter and battery pack. Versions are available for the following:
• Software Revision (inverter) for the complete package
• Battery System
• BiDcDc Controller
• Power 1 Controller
• Power 2 Controller
• Safety Controller
• System Controller
To Next Page
Loading...