SolarCity H6 - Page 88

H6 Hybrid Inverter - Installation & Operation Guide
78
Copyright 2017 SolarCity Corporation. All rights reserved.
• Grid voltage L2: Voltage of the grid L2 connection.
• Grid current: Current in amperes (A) being supplied to the grid.
• Grid frequency: Frequency of the grid, in Hz.
• Power factor:
- On-grid: 0.80 ... >0.99 (inductive/capacitive)
- Off-grid: 0.20 ... >0.99 (inductive/capacitive), current limited
• System state: Current state of the system. This can be one of the following:
- Grid-tied: If on-grid and producing power.
- Off-grid: If off-grid and producing power.
- System error: If there is an error or fault in the system.
• PV 1 voltage: Voltage being produced by the PV modules on the MPPT 1 channel.
• PV 2 voltage: Voltage being produced by the PV modules on the MPPT 2 channel.
• PV 1 current: Current being produced by the PV modules on the MPPT 1 channel, in
amperes (A).
• PV 2 current: Current being produced by the PV modules on the MPPT 2 channel, in
amperes (A).
• Battery current: Current battery pack output current at the interface.
• Battery voltage: Current battery pack output voltage at the interface.
• Battery state of charge: Current battery pack SOE capacity, in percent (0-100% in 1%
increments).
• Battery status: Current battery status (such as charging , discharging , or standby ).
• Battery SN: Serial number of the battery
• Charge/Discharge power: Amount of power being used to charge or discharge the
battery pack, in watts.
• R isolation: PV array impedance, in mega ohms (MOhm).
• Temperature: Current temperature in degrees Celsius.
• Software revision vers: SolarCity H6 inverter firmware version package number.
• Date: Current month, day, and year (received from the SolarCity server and adjusted for
geographical location).
• Time: Current time received from the SolarCity server and adjusted for geographical
location).
• Type: Inverter type.
• SN: Serial number of the SolarCity H6 inverter, as displayed on the name plate ratings
label.