SolarWinds UDT - Page 111

SolarWinds Core Components
1.
On the Device Types to Import page, check the device types you want
SolarWinds UDT to monitor, and then click Next.
Note: If you are not sure you want to monitor a specific device type, check the
device type in question. If, later, you do not want to monitor a selected device,
simply delete the device using Web Node Management. For more information,
see "Managing Devices in the Web Console"
2. If you are discovering devices for an SolarWinds NPM installation, check
the interface types you want SolarWinds UDT to monitor on the Interface Types
to Import page, and then click Next.
Note: If you are not sure you want to monitor a specific interface type, check
the interface type in question. If, later, you do not want to monitor a selected
interface, delete it using Web Node Management. For more information, see
"Managing Devices in the Web Console"
3.
On the Volume Types to Import page, check the volume types you want
SolarWinds UDT to monitor, and then click Next.
Note: If you are not sure you want to monitor a specific volume type, check the
volume type in question. If, later, you do not want to monitor any volume of the
selected type, delete the volume using Web Node Management. For more
information, see "Managing Devices in the Web Console"
4. If you want to import nodes, even when they are already known to be
polled by another polling engine, check the option in the Allow Duplicate
Nodes section. For more information about working with multiple polling
engines, see "Managing SolarWinds UDT Polling Engines"
5. If you are discovering devices for an SolarWinds NPM installation, check
valid states for imported interfaces on the NPM Import Settings page, and then
click Next.
Note: By default, SolarWinds UDT NPM imports interfaces that are discovered
in an Operationally Up state. However, because interfaces may cycle off and on
intermittently, the Import Settings page allows you to select interfaces found in
Operationally Down or Shutdown states for import, as well.
6. If there are any devices on the Import Preview that you do not ever
want to import, check the device to ignore, and then click Ignore. Selected
nodes are added to the Discovery Ignore List. For more information, see "Using
the Discovery Ignore List."
7.
Confirm that the network objects you want to monitor are checked on the
Import Preview page, and then click Import.
111