6. Expand the Advanced Filtering Options tree and select the desired options:
a. Check Active Status or Inactive Status depending on whether you want to actively monitor the
ports or not.
b. Check Trunk if you only want to select trunk (uplink) ports in the filter. If Trunk is not checked,
then both trunk ports and access ports will be selected in the filter.
c. Specify Port Range using values separated by commas. HP uses a convention of 1-48. Cisco
uses a row/port notation (and a switch/row/port notation for stacked switches). An example
for Cisco is: 0/1-48, 1/1-48,1/1-24 etc.
d. Specify VLAN as an integer ranging from 1-4095. You can provide a comma-separated list or
range. For example: 1,2,5,6-20,66.
e. Specify Port Description for each port by specifying a different description on each line using
strings, *, or regular expressions. For information about using regular expressions, refer to
Appendix C, "Regular Expression Pattern Matching".
7. Expand the Device tree at the bottom of the page and select the desired ports:
8. Click Filter All Ports Below to apply the selected filtering options to the selected ports. If you want to
undo the filtering, deselect the Advanced Filtering Options chosen previously and click Filter All
Ports Below. Then click the check box next to the Name column (or the check box next to each
desired device name) to restore all the discovered ports.
9. Click NEXT to begin monitoring the selected ports.
10.
If you want to setup devices on a Watch List, so that you are alerted when they are seen on the
network, click Next.
11. Click Add Device.
12.
Add the MAC address, IP address, or hostname.
13.
Give the device a descriptive name by which to recognize it in alerts.
14. Click OK.
15. Click OK, I'M DONE to return to Home, or click SETUP WATCH LIST to set up a watch list for selected
hostnames and MAC addresses on your monitored ports.
Adding Orion Nodes to UDT
User can display and monitor Orion Nodes with UDT by following the steps below.
1. Go to Settings near the top right of the application window.
2. Select UDT Setting under Product Specific Settings.
3. Under Port Management, choose show Nodes and filter to UDT Unmonitored Nodes.
4. Select the Nodes that need to be monitored by UDT and click Monitor with UDT.
5. A notification banner appears "New Ports will be imported to UDT by next polling interval".
Event Notification for Nodes and Ports added to UDT
To know whether an Orion node was added to UDT, event notifications are triggered and can be found in
the Last 25 Events resource in the UDT summary page.
Types of Event Notifications:
44
To Next Page
Loading...