SolarWinds UDT - Ignoring Endpoints in the White List by Adding Rules; Ignoring Endpoints in the White List by Enabling Rules

You ignore endpoints in UDT by adding or enabling rules:
n
Adding Rules
n
Enabling Rules
Note: Wireless endpoints cannot be ignored. Exclusion rules do not apply to them.
Ignoring Endpoints in the White List by Adding Rules
You can ignore endpoints in the white list by adding rules (described below) or by
enabling rules.
Follow these steps to ignore endpoints in UDT by adding new rules.
1. Click Add New on Ignored.
2. Click a Selection Method and add the appropriate information.
n Device (to add endpoints associated with a UDT device)
n Enter the appropriate string. Click Add More to add another
device, as needed.
n IP Range or MAC Range (to add multiple endpoints)
n Enter the Start address and End address. Click Add More to add
another range, as needed.
n Subnet (to add endpoints on an entire subnet)
n Click the plus icon (+) and, in Add New Subnet, enter strings for the
Subnet Address and Subnet Mask. Then click ADD.
n Custom
n Select a target and enter appropriate patterns. Enter each one on a
separate line.
3. Click Next.
4.
Optionally, enter a name for and description to help track why you added the
device(s) to the white list.
5. Click FINISH.
Ignoring Endpoints in the White List by Enabling Rules
You can ignore endpoints in the white list by adding rules or by enabling rules
(described below).
To ignore endpoints in UDT by enabling existing rule:
56
Ignoring Endpoints in the White List by Adding Rules