SolarWinds UDT - Add Endpoints to the Whitelist by Enabling Rules; Removing Endpoints from the White List; Removing Endpoints from the White List by Editing Rules

1. Click Add New on Included.
2. Click a Selection Method and add the appropriate information.
n Device (to add endpoints associated with a UDT device)
n Enter the appropriate string. Click Add More to add another
device, as needed.
n IP Range or MAC Range (to add multiple endpoints)
n Enter the Start address and End address. Click Add More to add
another range, as needed.
n Subnet (to add endpoints on an entire subnet)
n Click the plus icon (+) and, in Add New Subnet, enter strings for the
Subnet Address and Subnet Mask. Then click ADD.
n Custom
n Select a target and enter appropriate patterns. Enter each one on a
separate line.
3. Click Next.
4.
Optionally, enter a name for and description to help track why you added the
device(s) to the white list.
5. Click FINISH.
Add Endpoints to the Whitelist by Enabling Rules
You can add endpoints to the White List by adding rules or by enabling rules
(described below).
To enable a rule or rules:
1.
Select the rule in the list.
2. Click Enable.
Removing Endpoints from the White List
You remove endpoints from the White List by modifying or disabling inclusion rules:
n
Editing Rules
n
Disabling Rules
Removing Endpoints from the White List by Editing Rules
You can remove endpoints from the white list by editing rules (described below) or by
disabling rules.
54
Add Endpoints to the Whitelist by Enabling Rules