SolarWinds UDT - General Thresholds; General Threshold Types

Managing the Orion Web Console
3.
If you are using 64-bit counters, select Method 2 in the Counter Rollover
field in the Calculations & Thresholds area.
Notes:
n If Method 2 is selected, SolarWinds UDT will intentionally skip a poll if a
polled value is less than the previous polled value to permit counting to
2
64
.
n Orion fully supports the use of 64-bit counters; however, these 64-bit
counters can exhibit erratic behavior in some implementations. If you
notice peculiar results when using these counters, disable the use of 64-
bit counters for the problem device and contact the device
manufacturer.
4. If you are using of 32bit counters, select Method 1 in the Counter Rollover
field in the Calculations & Thresholds area. Please note that if Method 1 is
selected, when a rollover is detected, the time between polls is calculated as
(2
32
- Last Polled Value) + Current Polled Value.
General Thresholds
Many of the resources available in the Orion Web Console are capable of displaying
error and warning conditions for the devices on your network. Errors and warnings
display in the Orion Web Console. SolarWinds UDT uses the values provided on the
thresholds pages to determine when and how to display errors and warnings in the
Orion Web Console. The following sections provide more information about threshold
types and configuration:
n
General Threshold Types
n
Setting General Thresholds
General Threshold Types
The following device conditions may be configured as General Thresholds:
CPU Load
Monitored network devices experiencing CPU loads higher than the value set
for the High Level display in High CPU Load reports and resources. Gauges for
these devices also display as bold red. Monitored network devices experiencing
a CPU load higher than the value set for the Warning Level, but lower than the
value set for the High Level, display as red in High CPU Load reports and
resources. Gauges for these devices also display as red.
128