Managing the UDT White List
Follow these procedures to remote endpoints from your White List by editing existing
rules.
1. Click Included.
2. If you need to modify an existing rule, select the rule and click Edit.
3. Modify the information under Input (which displays one of the following
depending on how you initially defined the rules).
n Device
n Enter the appropriate string. Click Add More to add another
device, as needed.
n IP Range or MAC Range
n Enter the Start address and End address. Click Add More to add
another range, as needed.
n Subnet
n Click the plus icon (+) and, in Add New Subnet, enter strings for the
Subnet Address and Subnet Mask. Then click ADD.
n Custom
n Select a target and enter appropriate patterns. Enter each one on a
separate line.
4. Click Next.
5.
Optionally, enter a name for and description to help track why you added the
device(s) to the white list.
6. Click FINISH.
Remove Endpoints from the White List by Disabling Rules
You can remove endpoints from the white list by editing rules or by disabling rules
(described below).
To remote endpoints from your White List by disabling existing rules:
1.
Select the rule in the list.
2. Click Disable.
Ignoring Endpoints in UDT
UDT uses ignore rules to determine which endpoints connected to UDT-monitored
devices are irrelevant to tracking. Endpoints UDT determines are irrelevant, in that
they are covered by White List rules, do not appear in UDT resources.
55
To Next Page
Loading...