Installing SolarWinds User Device Tracker
SolarWinds User Device Tracker offers an intuitive wizard to guide you through installing and configuring
the product.
SolarWinds User Device Tracker does not require SolarWinds NPM. However, if you are performing a clean
install of SolarWinds UDT 3.1 and also want to install SolarWinds NPM, you should install SolarWinds NPM
version 11.0.1 or later before or after you install SolarWinds UDT 3.1. For more information, see "Installing
SolarWinds Network Performance Monitor" in the SolarWinds Network Performance Monitor Administrator
Guide.
Note: If you have any additional SolarWinds UDT web consoles or pollers, you must upgrade them too by
repeating this procedure for each additional SolarWinds UDT poller or web console. Be sure to use the
correct installers for pollers or web consoles, since these are different from the standard installer package.
For information about installing additional Orion Web Consoles or pollers, refer to the Chapter "Additional
Polling Engine and Web Console"
To install or upgrade SolarWinds User Device Tracker:
1.
Using a local administrator account log on the server where you want to install or upgrade
SolarWinds UDT.
2. If you downloaded the product from the SolarWinds website, navigate to your download
location and launch the executable.
3.
If you are prompted to install requirements, click Install, and then complete the installation,
including a reboot, if required.
Notes:
n Downloading and installing Microsoft .NET Framework 3.5 may take up to 20 minutes or
more, depending on your existing system configuration.
n If a reboot is required, after restart, click Install to resume installation, and then click Next on
the Welcome window.
4.
If the Microsoft Installer Wizard detects that Microsoft Internet Information Services (IIS) is
not installed, select Suspend installation to manually install IIS, click Next, quit setup, and then
install IIS as shown in one of the following sections, depending on your platform:
n Enabling IIS on Windows Server 2003 and Windows XP
n Enabling IIS on Windows Vista and Windows Server 2008 (R2) R2
n Enabling IIS on Windows 7
The Orion Web Console requires that Microsoft IIS is installed on the SolarWinds UDT Server.
If you do not install IIS at this point, you must install IIS later, and then configure a website for
the Orion Web Console to use.
5.
Read the message about the Orion Improvement Program. If you are willing to send anonymous data
back to SolarWinds for product improvement, click Send data. Otherwise, click Do not send data.
Notethat you can stop sending this data at any time by uninstalling the Orion Improvement Program
using the Control Panel.
6. Read the welcome message, and then click Next.
29
To Next Page
Loading...