SolarWinds UDT - Using the Network Sonar Discovery Results Wizard

16. If you want the discovery you are currently defining to run on a regular
schedule, select either Custom or Daily as the discovery Frequency, as shown
in the following steps:
Notes:
n Scheduled discovery profiles should not use IP address ranges that
include nodes with dynamically assigned IP addresses (DHCP).
n Default Discovery Scheduling settings execute a single discovery of your
network that starts immediately, once you click Discover.
n Results of scheduled discoveries are maintained on the Scheduled
Discovery Results tab of Network Discovery. For more information
about managing scheduled discovery results, see "Managing Scheduled
Discovery Results"
a. If you want to define a custom discovery schedule to perform the
currently defined discovery repeatedly in the future, select Custom
and then provide the period of time, in hours, between discoveries.
b. If you want your scheduled discovery to run once daily, select Daily,
and then provide the time at which you want your discovery to run every
day, using the format HH:MM AM/PM.
17. If you do not want to run your network discovery at this time, select No,
don't run now, and then click Save or Schedule, depending on whether you
have configured the discovery to run once or on a schedule, respectively.
18. If you want your Network Sonar discovery to run now, click Discover to
start your network discovery.
Note: Because some devices may serve as both routers and switches, the total
number of Nodes Discovered may be less than the sum of reported Routers
Discovered plus reported Switches Discovered.
Using the Network Sonar Discovery Results Wizard
The Network Sonar Results Wizard directs you through the selection of network
devices for monitoring, and it opens whenever discovery results are requested, either
when the Network Sonar Discovery Wizard completes or when either Import All
Results or Import New Results is clicked for a selected discovery. For more
information, see "Network Discovery Using the Network Sonar Discovery Wizard"
The following steps detail the selection of discovered objects for monitoring in
SolarWinds UDT.
To select the results of a network discovery for monitoring in SolarWinds UDT:
110
Using the Network Sonar Discovery Results Wizard