n
Using GET or POST URL Functions
n
Dial Paging or SMS Service
Sending an E-mail / Page
The following procedure configures an e-mail/page action for an advanced alert.
Note: Emails and pages are sent in plain text.
1. Click E-mail/Pager Addresses.
2.
Complete the To, CC, BCC, Name, and Reply Address fields.
Note: You must provide at least one email address in the To field, and multiple
addresses must be separated with commas. Some pager systems require a
valid reply address to complete the page.
3. Click Message.
4. Select the format (Plain text or HTML) for your alert email.
5.
Type the Subject and Message of your alert trigger email/page.
Note: Messaging is disabled if both Subject and Message fields are empty.
6.
If you want to insert a variable into the Subject or Message field, click the
location of the new variable, and then complete the following procedure:
a. Click Insert Variable.
b. Select a Variable Category, and then select the variable to add.
c. If you want to change the parser, check Change Parser, and then
select the parser you want to use.
d. If you want to define the SQL variable to copy to the clipboard,
check Define SQL Variable, and then click Insert Variable From Above
List.
e. Click Build Selected Variable.
7. Click SMTP Server.
8.
Type the Hostname or IP Address of your SMTP Server and the designated
SMTP Port Number.
Note: The SMTP server hostname or IP address field is required. You cannot
send an email/page alert without identifying the SMTP server.
9. If you want to use SSL/TLS encryption for your alert email, check Enable
SSL.
10. If your SMTP server requires authentication, check This SMTP Server
requires Authentication.
11. Click Time of Day.
229
Sending an E-mail / Page
To Next Page
Loading...