SolarWinds UDT - Adding Devices for Monitoring in the Web Console

Managing Devices in the Web Console
Adding Devices for Monitoring in the Web
Console
The following procedure details the steps required to add a device for monitoring in
the Orion Web Console.
Note: This procedure does not specifically address the addition of objects that are
specifically monitored solely by individual SolarWinds products, as in the case of
monitoring interfaces with SolarWinds NPM. For more information about adding
interfaces, see the SolarWinds Network Performance Monitor Administrator Guide.
To add a device for monitoring in the Orion Web Console:
1.
Log in to the Orion Web Console as an administrator.
2. Click Settings in the top right of the web console.
3. Click Manage Nodes in the Node & Group Management grouping of the Orion
Website Administration page.
4. Click Add Node on the Node Management toolbar.
5.
Provide the hostname or IP Address of the node you want to add in the
Hostname or IP Address field.
6. If the IP address of the node you are adding is dynamically assigned,
check Dynamic IP Address.
7. If you only want to use ICMP to monitor node status, response time, or
packet loss for the added node, check ICMP (Ping only).
168