SolarWinds UDT - Setting a Reset Condition for an Advanced Alert

Using Orion Platform Advanced Alerts
e. If you need to delete a condition, click Browse (...), next to the
condition you want to delete, and then click Delete Current Condition.
Notes:
n Conditions may be exported for use with other alerts by clicking
Export Conditions and saving as appropriate.
n Click Import Conditions to import existing conditions from other
alerts. Imported trigger conditions automatically overwrite any
existing trigger conditions.
f. If you want to specify a time duration for the condition to be valid,
type the interval and select Seconds, Minutes, or Hours from the list.
Note: You may need to delay alert trigger actions until a condition has
been sustained for a certain amount of time. For example, an alert based
on CPU load would not trigger unless the CPU Load of a node has been
over 80% for more than 10 minutes. To set up a sustained-state trigger
condition, at the bottom of the Trigger Condition tab, provide an
appropriate amount of time the alert engine should wait before any
actions are performed. By default, the alert triggers immediately, if the
trigger condition exists. The maximum alert action delay is eight hours
after the trigger condition is met.
g. If you are finished configuring your advanced alert, click OK.
Setting a Reset Condition for an Advanced Alert
Set specific conditions for resetting an advanced alert using the following steps.
1. Click Start > SolarWinds > Alerting, Reporting, and Mapping > Advanced Alert
Manager.
2. Click View > Configure Alerts, and then click New or select an alert from the list
and click Copy or Edit.
3. Click Reset Condition.
4. If you want a simple alert reset when trigger conditions no longer exist,
select Reset when trigger conditions are no longer true.
5.
If you want a conditional alert reset, select Reset this alert when the
following conditions are met.
Notes: Generate reset conditions in the text field by selecting appropriate
descriptors from the linked context menus and by clicking Browse (...).
6. If you want to copy the condition used on the Trigger Condition tab, click
Copy From Trigger.
7.
Click the linked text to select the number of conditions to apply. For more
information, see "Understanding Condition Groups"
218