Managing SolarWinds UDT Polling Engines
Perform reverse DNS lookup
If you want SolarWinds UDT to perform reverse DNS lookups on monitored
DHCP nodes, confirm that this option is checked. By default, reverse DNS
lookup for DHCP nodes is enabled.
Calculations & Thresholds
The following settings designate methods for calculating availability and
transmission rate baselines, select the SolarWinds UDT node warning level and
counter type, and indicate security preferences for community strings and other
potentially sensitive information in the web console.
Availability Calculation (advanced)
This setting designates the type of calculation SolarWinds UDT performs to
determine device availability. For more information, see "Calculating Node
Availability"
Baseline Calculation (advanced)
Upon startup, Orion can calculate a baseline for the transmission rates of the
various elements of your network. This baseline is used as a starting point for
any comparison statistics. For more information, see "Calculating a Baseline."
Allow Secure Data on Web (advanced)
In the interest of security, sensitive information about your network is not
viewable in the Orion Web Console. However, if your network is properly
secured, you may check this option to allow the viewing of community strings
and other potentially sensitive information within the web console.
Note: This setting does not affect the display of custom reports that you export
to the web. For more information see "Creating and Viewing Reports"
Node Warning Level
Devices that do not respond to polling within this designated period of time
display as Down in the web console. By default, this value is 120 seconds.
Counter Rollover
This option sets the type of counter SolarWinds UDT is to use. For more
information, see "Handling Counter Rollovers."
203
To Next Page
Loading...