10.
If you want to limit rule application to within a specific period of time,
select the Time of Day tab, check Enable Time of Day checking, enter the time
period, and then check the days of the week on which to apply the rule.
Notes:
n Enabling Time of Day checking creates more overhead for the CPU.
n Messages received outside the specified timeframe will not trigger
alerts.
11. If you want to suppress alert actions until a specified number of
messages arrive that match the rule, complete the following procedure:
a. Select the Trigger Threshold tab.
b. Check Define a Trigger Threshold for this Rule.
c.
nter option values as appropriate.
Note: When Suspend further Alert Actions for is checked, alert actions
are not sent until the specified amount of time has expired. Once the
time period has expired, only new alerts are sent. All alerts suppressed
during the time period are discarded.
12.
Configure Syslog alert actions on the Alert Actions tab, as shown in the
following steps:
a. If you are associating a new action to the rule, click Add New Action.
For more information about available actions, see "Available Syslog Alert
Actions"
b. If you want to edit an existing action for the rule, select an action
from the list, and then click Edit Selected Action.
c.
Configure the action as appropriate. For more information about
available actions, see "Available Syslog Alert Actions."
Note: Syslog alerts use a unique set of variables.
d. If you need to delete an action, select the action, and then click
Delete Action.
e.
Use the arrow buttons to set the order in which actions are performed.
Note: Actions are processed in the order listed, from top to bottom.
f. Click OK to save all changes and return to Syslog Viewer Settings.
13.
Use the arrow buttons to arrange the order in which the rules are applied.
Note: Rules are processed in the order they appear, from top to bottom.
291
Configuring Syslog Viewer Filters and Alerts
To Next Page
Loading...