Troubleshooting
1. Click Start > All Programs > Accessories.
2. Right-click Command Prompt, and then click Run as administrator.
3.
If you are prompted by User Account Control, click Continue to open the
elevated command prompt.
Note: In some cases, having User Account Control (UAC) enabled on Windows
Server 2008 and Windows Vista (evaluation-only) can lead to installation errors.
For more information about disabling UAC, see "Disable User Account Control
(UAC)".
4.
At the prompt, enter the following:
netsh interface tcp set global autotuninglevel=disabled
5.
Close the command prompt window, and then restart your Server.
360
To Next Page
Loading...