207Snapshot Operations From the Numeric Keypad Control Block
Chapter 14 Snapshots
a) The GPI port that can be set is 1 (fixed).
For details of attributes, see “Snapshots” in Chapter 1 (Volume 1).
Note
In the numeric keypad control block, it is not possible to apply the cross-
point hold. For details, see “Applying snapshot attributes” (page 210).
7
Press the [ENTER] button.
This saves the snapshot, and the [STORE] button goes off. The [RCALL]
and [STORE STATS] buttons light.
To cancel a snapshot save operation
After saving a snapshot, to cancel the save, hold down the [STORE STATS]
button and press the [UNDO] button.
Recalling a snapshot from the numeric keypad control block
Use the following procedure.
1
In the numeric keypad control block, press the [SNAPSHOT] button,
turning it on.
This allocates the numeric keypad control block to snapshot operations,
and the [RCALL] button lights.
2
Press the region selection button corresponding to the region you want to
recall, turning it on. Multiple selections are also possible.
[M/E 1], [P/P]: These select the M/E-1 and PGM/PST regions.
[USER 1] to [USER 8]: These select the user regions.
[DME 1] to [DME 4]: These select the DME channels.
[ALL]: This selects all regions.
[MASTR]: This selects a master snapshot.
Note
The regions that can be selected simultaneously are those assigned to the
region selection buttons in the numeric keypad control block. (See
“Assigning the region selection buttons in the numeric keypad control
block” (page 254).)
It is not possible to select [MASTR] and other regions simultaneously. If
selected simultaneously, the master snapshot takes precedence.
To Next Page
Loading...
