Sony DVS-9000SF - Page 335

335Setup Relating to DCU
Chapter 16 Engineering Setup
9 Repeat steps 5 to 8 as required to set the constants for other VTRs.
To make detailed settings for a disk recorder (Sony disk 9-pin
protocol)
Use the following procedure.
1 In the <DCU Select> group of the DCU>Serial Port Assign menu, select
the target for the setting (DCU1 or DCU2).
2 Using any of the following methods, select the serial port connected to the
disk recorder for which you want to make the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
3 Press [Port Setting].
The DCU>Serial Port Assign>DDR SD9P Setting menu appears.
At the top of the status area, the relevant serial port, slot number, protocol,
serial port name, SCU number, and disk recorder type appear. In the lower
part of the status area, the response speed settings appear.
4 Using any of the following methods, specify the item to which the
response speed setting applies.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) 1. Maximum Open Delay: maximum time required to open a file
2. Maximum Cueup Delay: maximum time required to cue up a file
3. Play After Cueup Delay: maximum delay time from the cued-up state to begin playback
4. Play After Open Next Delay: maximum delay time from the Open Next state to begin
playback
5 Turn the knob to set the disk recorder response speed.
Knob Parameter Adjustment Setting values
1 Port No Serial port
1 to 30
Knob Parameter Adjustment Setting values
1 Item No Item selection
1 to 4
a)
Knob Parameter Adjustment Setting values
2 Setting Response speed setting 0 to 255