Chapter 16 Engineering Setup
336
Setup Relating to DCU
6
Press [Set].
This confirms the setting.
7
Repeat steps 4 to 6 as required to make the settings for other items.
To make detailed settings for a disk recorder (video disk
communications protocol)
Use the following procedure.
1
In the <DCU Select> group of the DCU>Serial Port Assign menu, select
the target for the setting (DCU1 or DCU2).
2
Using any of the following methods, select the serial port connected to the
disk recorder for which you want to make settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
3
Press [Port Setting].
The DCU>Serial Port Assign>DDR VDCP Setting menu appears.
At the top of the status area, the relevant serial port, slot number, protocol,
serial port name, SCU number, and disk recorder type appear.
In the lower part of the status area appear the video port number and
response speed settings.
4
In the <DDR Type> group, select the type of disk recorder.
Player: Functioning as a player.
Recorder: Functioning as a recorder.
5
Using any of the following methods, specify the item to which the video
port number or response speed setting applies.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) 1. Video Port: Number of the video port associated with the serial port to which the setting
applies
For a player, the output port setting
Knob Parameter Adjustment Setting values
1 Port No Serial port 1 to 30
Knob Parameter Adjustment Setting values
1 Item No Item selection
1 to 5
a)
To Next Page
Loading...
