5 Operation
Working with attachments
7081_003-016
Depressurising, multi-lever controls
– Lower fork carriage to the ground, tilt mast
as far back as possible.
– Switch off the key switch.
– Operate all hydraulic operating levers (ar-
rows) multiple times up to their end posi-
tions.
General information on control of
attachments
The control of attachments (option) depends
on the type of attachment.
WARNING
The use of attachments can result in additional ha-
zards such as, for example, a change in the centre
of gravity, additional danger zones, etc.
Attachments may only be used for their intended
purpose as described in the relevant operating
instructions. The driver must be instructed in the
handling of the attachments.
Loads may only be picked up and transported with
attachments if they can be seized and held pro-
perly. If necessary, the loads must also be secured
against sliding, rolling, falling over, swinging or fal-
ling off. Note that the stability of the truck changes
if the load centre distance is changed. Please refer
to the attachment load capacity plate.
NOTE
Further options and functions are possible in
addition to those listed below. The directions
of movement are shown on the pictograms on
the control levers or on the valve cover.
118 171673 [EN]
To Next Page
Loading...
Need help?
General
