Safety 3
Emissions
Emissions
Noise emissions
The values were determined based on
measurement procedures from the standard
EN 12053 (noise measurement for industrial
trucks based on EN 12001 and EN ISO 3744
and the requirements of EN ISO 4871). This
machine emits the following sound-pressure
levels:
Continuous sound-pressure level in the driver’s compartment
L
pAZ
<76dB(A)
Uncertainty K
pA
4dB(A)
The values were determined in the test cycle
on an identical machine from the weighted
values for operating conditions and idling.
Time percentages:
• Lifting 18%
• Idling 58%
• Driving 24%
However, the indicated noise levels at the
truck cannot be used to determine the noise
emissions at workplaces according to the
most recent version of Directive 2003/10/EC
(daily personal noise pollution). If necessary,
these should be determined directly at the
workplace under the actual conditions there
(additional noise sources, special operating
conditions, sound reflections) by the operating
company; (see ⇒ Chapter "Definition of terms
used for responsible persons", P. 20).
Vibrations
The vibrations of the machine must be deter-
mined on an identical machine in accordance
with the standard EN 13059 "Vibration mea-
surements on industrial trucks".
Weighted effective value of the acceleration the body
(feet or seat surface) is subjected to
<0.6m/s
2
Uncertainty K
0.18 m/s
2
Tests have indicated that the amplitude of the
hand and arm vibrations on the steering wheel
171673 [EN] 37
To Next Page
Loading...
Need help?
General
