Maintenance 6
Maintenance as required
7071_003-097
4
– Open the cover fastenings (4) and remove
the cover.
– Replace the defective fuse, fuse assign-
ment see ⇒ Chapter "Fuse assignment
special equipment", P. 7-254.
– Push down the cover until the cover fasten-
ings (4) snap back into place.
– Refit the cover (3) and tighten the fixing
screws (2).
7090_860-004
Attachment maintenance
– Lubricate the slide rails of attachments
(special equipment), such as a sideshift or
clamp according to the maintenance data
table. See ⇒ Chapter "Maintenance data
table", P. 6-186appears on the display.
The diagram shows a clamp.
NOTE
Observe the manufacturer’s maintenance
specifications.
171673 [EN] 221
To Next Page
Loading...
Need help?
General
