5 Operation
Operation in special operating situations
CAUTION
Risk of damage to components!
Under no circumstances should the engine be shut
off via the ignition when the evaporator is iced up,
since very cold residual gas still in the evaporator
chamber could thermally expand as it warms to
the ambient temperature, leading to impermissible
excess pressure in the evaporator chamber.
-
+
2
1
+
-
7311_606-001
Jump starting
DANGER
Risk of explosion from spark
discharge!
While connecting, make sure that
cables do not come into contact with
metallic parts of the vehicle.
DANGER
Risk of explosion!
If the forklift has been shut away
for a long period in a closed room,
ventilate the area well before
switching on the electrical system.
NOTE
A power source with 12 V (e.g. second forklift
truck of same type) must be available.
– Open the bonnet; see ⇒ Chapter "Opening
the bonnet", P. 5-55.
– Disassemble base plate; see ⇒ Chap-
ter "Installing and removing the floor-
plate", P. 6-194
– Allow the engine in the vehicle providing the
current to run.
– Connect the positive cable (2) to the positive
terminal on the dead battery first and then
connect it to the positive terminal of the
current-providing battery.
– Connect the negative cable (1) to the nega-
tive terminal of the current-providing battery
first and then connect it to the negative ter-
minal of the dead battery.
160 171673 [EN]
To Next Page
Loading...
Need help?
General
