5 Operation
Checks and operations prior to start-up
3
4
7311_120-002
– Insert the release tool (3) and release the
catch. To open it, use the release tool from
the accessories.
NOTE
The catch can be secured with a lock. If ne-
cessary, open the lock beforehand.
– Using the handle (4) next to the driver’s
seat, open the bonnet towards the rear.
WARNING
Risk of accident!
The release tool must always remain with the truck,
so that the bonnet can be opened at any time, even
in an emergency!
7081_003-035
1
Checking the engine oil level
NOTE
The vehicle should be as level as possible
when performing this check.
– Remove and wipe off dipstick.
– Insert dipstick to contact and pull out again.
The oil level must be between the markings
(arrows).
– If the oil level only reaches the bottom mark,
unscrew filler cap and add oil according
to maintenance data table(1). ⇒ Chap-
ter "Maintenance data table", P. 6-186.
56 171673 [EN]
To Next Page
Loading...
Need help?
General
