Still R70-40T User Manual

6 Maintenance
3000-hour maintenance/two-year maintenance
7071_003-118
2
3
– Unscrew the checking screw (2).
– Unscrew the filling plug (3) and fill with
oil as per the maintenance data table
(see ⇒ Chapter "Maintenance data ta-
ble", P. 6-186) until it escapes from the hole
for the checking screw (2).
– Change the sealing ring on the checking
screw (2).
– Tighten the checking screw (2) to a torque
of 10 Nm.
– Change the sealing ring on the filling plug
(3).
– Tighten the filling plug (3) to a torque of
24 Nm.
– Change the gear lubricant oil of both wheel
drives.
– Refit the wheels to the drive axle; for tight-
ening values see ⇒ Chapter "Maintenance
data table", P. 6-186.
Checking the wheel bearing
– Check the wheel bearing for excessive play,
stiffness, damage, and wear.
Have STILL service personnel replace parts
in the event of play or wear.
7311_003-030
Checking the engine mountings
– Check all engine mountings for security and
wear, and replace them if necessary.
236 171673 [EN]

Still R70-40T Specifications

General

Brand	Still
Model	R70-40T
Category	Forklifts
Language	English