6 Maintenance
Safety instructions for maintenance
Safety instructions for maintenance
General information
To prevent accidents during maintenance and
repair work, all necessary safety measures
must be taken, e.g.:
• Ensure that unintentional movement or
undesired start-up of the forklift truck is pre-
vented (apply the parking brake, jack up the
forklift truck).
• Secure against lowering when working un-
der raised load-carrying equipment.
• Secure the mast against unintentional tilt-
ing.
Carrying out work on the hydraulic
equipment
Hydraulic equipment must be depressurised
prior to all work. See ⇒ Chapter "Depressuris-
ing connections for attachments", P. 5-117.
Working on electrical equipment
Work may only be performed on electrical
equipment of the forklift truck in a voltage-free
state. Only trained and commissioned per-
sons may perform functional tests, checks,
and settings on parts under voltage while
taking the suitable precautionary measures.
Rings, metal bracelets, etc. must be removed
prior to working on electrical components.
To prevent damage to e-systems with elec-
tronic components, such as an electronic driv-
ing regulator or lift control, these components
must be removed from the forklift truck prior to
the start of electric welding.
Work on the electrical system (e.g. connecting
a radio, additional headlights, etc.) must be
approved by us.
188 171673 [EN]
To Next Page
Loading...
Need help?
General
